Building setbacks, fence regulations, and zoning requirements for Gilmer County.
Search Your Property FreeSetback requirements determine how far structures must be from property lines. The minimums below come from the Gilmer County code for homes in unincorporated areas; your parcel's zoning district can change them.
Figures are for the R-1 district. Front setback is 40 ft from the right-of-way of any county, public or state road and 25 ft from an interior subdivision road. Previously platted lots keep the setbacks on the recorded plat or covenants. Accessory buildings meet the same setbacks; well houses are exempt. A-1 is 25 ft side and 50 ft rear.
Source: Sec. 62-132 Table of land use districts and requirements therein; Sec. 62-128 Accessory buildings
Tree removal regulations for Gilmer County, Georgia.
Permit required: Contact county
Threshold: 8 in diameter at 4.5 ft
Applies only on protected mountains. Land-disturbing activity may not remove more than half of the trees over 8 in diameter without a reforestation plan by a registered forester; commercial building permits need a plan to replace removed trees. No countywide tree removal permit was found.
Source: Chapter 70, Article III Mountain Protection, Sec. 70-78(i)-(j) Protection criteria
Walk your land and see your boundaries drawn on the ground. See where setbacks apply. Searching any address is free.
Search Your Property FreeDisclaimer: This information is extracted from Gilmer County ordinances for reference only. Regulations vary by zoning district and may have changed. Contact the Gilmer County Planning Department for official guidance before building.
Ordinance text collected October 2026 from the county code. Code status: Supplement 44; codified through Ordinance No. 25-195(Res.), enacted December 15, 2025; online content updated July 17, 2026.
Get it on your phone — scan with your camera