Building setbacks, fence regulations, and zoning requirements for Robeson County.
Search Your Property FreeSetback requirements determine how far structures must be from property lines. The minimums below come from the Robeson County code for homes in unincorporated areas; your parcel's zoning district can change them.
Figures are for the R-1 district. Front yard is measured from the street right-of-way; two side yards of 10 ft each. Rear yard is 20% of mean lot depth but need not exceed 30 ft. Corner-lot street side yard 20 ft. R-2 has the same yards. R-A: 40 ft from the front line on soil roads, 70 ft from the center of state roads, 15 ft sides.
Source: Article III, Sec. 3.10 Area and Bulk Regulations (R-1) District (also 3.6 R-A, 3.12 R-2)
Walk your land and see your boundaries drawn on the ground. See where setbacks apply. Searching any address is free.
Search Your Property FreeDisclaimer: This information is extracted from Robeson County ordinances for reference only. Regulations vary by zoning district and may have changed. Contact the Robeson County Planning Department for official guidance before building.
Ordinance text collected October 2026 from the county code. Code status: Adopted November 16, 2020 (Sec. 1.11); the county PDF shows no later amendments.
Get it on your phone — scan with your camera