Building setbacks, fence regulations, and zoning requirements for Trempealeau County.
Search Your Property FreeSetback requirements determine how far structures must be from property lines. The minimums below come from the Trempealeau County code for homes in unincorporated areas; your parcel's zoning district can change them.
Figures are for the Rural Residential, Residential-8 and Residential-20 districts (agricultural districts also 10 ft side and rear). Front setback depends on the road: town highways 63 ft from centerline or 30 ft from the right-of-way, whichever is greater; county highways 75 or 42 ft; state and federal highways 110 or 50 ft. 75 ft from navigable water.
Source: Ch. 3, Sec. 3.02(2) Table of District Requirements; Sec. 3.05 Setbacks from highways; Sec. 3.06
Fence height limits and placement rules for Trempealeau County, Wisconsin.
On property line: Contact county
Fences are allowed in front, side and rear yards and within highway setbacks if not in a public right-of-way, and are exempt from the accessory-structure land use permit. No residential fence height limit found. Screening fences required by Sec. 3.10 must be opaque with posts facing the lot interior.
Source: Ch. 3, Secs. 3.05(7)(d), 3.08(2)(b), 3.11(1)(b), 3.10
Walk your land and see your boundaries drawn on the ground. See where setbacks apply. Searching any address is free.
Search Your Property FreeDisclaimer: This information is extracted from Trempealeau County ordinances for reference only. Regulations vary by zoning district and may have changed. Contact the Trempealeau County Planning Department for official guidance before building.
Ordinance text collected October 2026 from the county code. Code status: Chapter 3 revision Res. 2024-11-12 (PDFs dated 12/16/2025); amendments adopted late September 2026 not reflected.
Get it on your phone — scan with your camera