Building setbacks, fence regulations, and zoning requirements for White County.
Search Your Property FreeSetback requirements determine how far structures must be from property lines. The minimums below come from the White County code for homes in unincorporated areas; your parcel's zoning district can change them.
Figures are for the R-1 district; the same 30 ft front (from the road), 4 ft side and 20 ft rear apply in every residential and agricultural district. Within subdivisions the recorded plat setbacks apply. Accessory structures: 4 ft side and rear (20 ft rear in L-1). Lake-area lots need 20 ft along a road.
Source: Appendix B: Bulk Use Standards - Residential & Agricultural (Sec. 2.2.2)
Fence height limits and placement rules for White County, Indiana.
On property line: Contact county
Prohibited materials: barbed wire (residential districts), electric fence (residential districts)
No fence over 6 ft 6 in. In residential front yards (between the house front and the road), max 3.5 ft, and no more than 50% opaque in a front setback. Decorative fences up to 3 ft anywhere. A permit is needed inside town limits and Buffalo and Idaville; fences in a flood hazard area need an Indiana DNR permit. Farm fences are exempt.
Walk your land and see your boundaries drawn on the ground. See where setbacks apply. Searching any address is free.
Search Your Property FreeDisclaimer: This information is extracted from White County ordinances for reference only. Regulations vary by zoning district and may have changed. Contact the White County Planning Department for official guidance before building.
Ordinance text collected October 2026 from the county code. Code status: Updated through 09-24-2026 (Appendix B amended 04/20/2026, Ord. 2026-04-20-1).
Get it on your phone — scan with your camera